How much does it cost to rebuild a steering box?

How much does it cost to rebuild a steering box?

The Best in Auto Repair The average cost for steering gearbox replacement is between $878 and $1,056. Labor costs are estimated between $160 and $202 while parts are priced between $717 and $854. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.

How long does it take to rebuild a steering gear box?

The rebuild can easily be accomplished over a weekend, including the removal and reinstallation of the box. The Saginaw manual steering box first appeared in GM cars in ’55, and variations of that venerable box were used for decades.

Can a steering box be fixed?

Power Steering Box Repairs – The Rebuild Some steering boxes are relatively easy to rebuild and don’t require special tools while others are more difficult and do require special tools. While steering gearbox rebuilding can be done by yourself, it should only be done by someone with sufficient knowledge and skill.

Can you rebuild a manual steering gear box?

Manual Steering Gearbox Rebuilds All parts are solvent cleaned and prepared for reassembly. The unit is reassembled with new OEM (original equipment manufacturer) seals, bearings and other parts as needed. All settings and adjustments are set to factory specifications. Final testing is performed for function and leaks.

How do I identify my GM steering box?

This gearbox was found in GM trucks and SUV’s up to 1986. It is easy to identify because it mounts on the outside of the frame and the mounting tabs are on the opposite side of the gearbox. Notice how the mounting holes are on the top side of the gearbox.

How do you replace the seal on a power steering gear box?

Process

1. Disconnect the battery and lift the vehicle.
2. Remove the power steering gear from the car.
3. Clean the gearbox.
4. Remove the input shaft face cover.
5. Mark the cover and housing.
6. Remove bearing cap bolts and cover.
7. Pry the soft seal from the cap cover.
8. Drive the input shaft seal with a seal driver.

How do you test a power steering box?

A steering box check involves raising the front of the car but keeping its weight on the wheels, and getting underneath it while a helper turns the wheels a short way. The safest way of doing this is to drive on to a set of ramps — unless you can get access to a proper inspection pit.

How long does it take to change a gear box and clutch?

Changing a gearbox is one of the more complex tasks that you can perform in your home garage, but with a little preparation and planning, it can be done in around eight hours. As with all mechanical work on your car, you should only do the change on a flat surface in a dry area.

What wears out in a steering box?

Check the steering box for leaks and wear whenever you inspect the rest of the steering system. The box is filled with oil, so a leak can make the steering stiff. If you notice stiffness, check at once. A low oil level in the box is a sure sign of a leak.

How do you diagnose a bad steering box?

If a part is worn or failing, the issues below could result.

1. Vehicle continually pulls to one side while driving.
2. Continued bouncing after hitting a bump or pothole.
3. A steering pull or drift to one side after turning.
4. Steering slips while turning the wheel.