Where is the transfer case motor located?

Where is the transfer case motor located?

The transfer case shift motor is mounted on the outside of the transfer case and may even be a DIY job for someone with decent mechanic skills.

How do you reset a transfer case motor?

To reset and clear the transfer case control module, pull the five amp TCCM thread bridge at the bottom of the fuse box. Wait for at least 30 minutes and then replace the fuse. Next, turn the electric key and wait for the flashing of the 4×4 light. Turn your engine off after that.

Where is Transfer Case Control Module?

Generally, the TCCM can be found in the control panel on the steering column on the driver’s end.

How do I install the motor/encoder to the transfer case?

o When installing the motor/encoder unit to the transfer case, make sure that the transfer case is indexed properly and it is flat against the transfer case before tightening the mounting bolts. 1. Install the NEW motor/encoder gasket to the transfer case.

Can I operate encoder motors without installing?

I’ve bought a few encoder motors from the J/Y and they always have a factory sticker on them that specifically say that they CANNOT or SHOULD NOT be operated unless installed. They apparently have a lot fo torque and move very fast and would be damaged if you operated them uninstalled. (that last part was just a guess) More sharing options…

What should I do if the motor/encoder Assembly is defective?

o If the motor/encoder assembly is being replaced because it is defective, make sure that the transfer case is in the neutral position. Manually shift the unit at the shift shaft. Use a crescent wrench if necessary.

Where is the 4WD light on a 2000 GMC Sierra 1500?

On the 2000 GM truck, the com- plaint was no four-wheel drive, and the 4WD light in the IPC (instrument panel cluster) came on at times. (This warning light, located in the left-side LED indicator, can display various messages, from “Security” to “Low Fuel” and even “4WD/AWD.”)