How long does DITRA take to set?
25 to 30 minutes
Ditra-set only takes 25 to 30 minutes to dry. These advantages allow you to walk on the Ditra surface before tiling or even right after installing the Ditra. When installing ceramic and other stone tiles, Ditra is beneficial to use. It aids in a durable tile installation that will last for a long time.
What should I set my DITRA with?
To set DITRA over concrete or gypsum, Schluter-Systems recommends an unmodified thin-set mortar meeting the requirements of ANSI A118. 1. Please consult the Schluter-DITRA Installation Handbook before beginning your tile project to confirm the proper materials selection.
What is the difference between Schluter set and all set?
Schluter ALL-SET® is a specialized modified thin-set mortar specifically formulated for use with Schluter® membranes and boards. Schluter FAST-SET® is a specialized rapid-setting modified thin-set mortar specifically formulated for use with Schluter® membranes and boards.
Can you lay tile over DITRA right away?
Once DITRA has been installed on the substrate, tile can be installed right away. No need to wait for the mortar to cure.
How long do you wait to tile after installing DITRA?
After about 24 hours, it’ll be ready for tile, and meanwhile Jim and Rich are getting started on the over half.
Do you put Thinset under DITRA?
Since DITRA is impervious, it does not deprive the mortar of its moisture. This allows the cement to properly hydrate, resulting in a strong, dense bond coat. In general, we don’t recommend the use of modified thin-set mortar to set tile over the membranes because these mortars must air dry to cure properly.
How much thinset do I need?
Amount of Thinset Needed Divide the square footage of your project by 95 (the maximum coverage of a 50-pound bag of thinset. For example, a 10-by-12-foot room is 120 square feet; divided by 95, the result is 1.26. Round the number up to the next whole number.
What happens if you use modified thinset on DITRA?
How long does Schluter all set last?
2-4 hours
In standard conditions (70ºF and 50% RH) Schluter SET® and Schluter ALL-SET® have a pot life of 2-4 hours. Schluter FAST-SET® has a pot life of 30 mins in standard conditions.
Can DITRA be walked on?
Pro-Tip: DITRA can be walked on immediately after; there’s no need to wait for the mortar to cure.
How much mortar do I use to install Ditra?
To bond DITRA and DITRA-XL to the substrate: Use one 50 lb. (22.68 kg) bag of mortar per 150 – 200 ft 2 (13.9 – 18.6 m 2 ). To bond tile to DITRA, using a 1/4″ x 3/8″ (6 mm x 10 mm) square- or U-notched trowel: Use one 50 lb (22.68 kg) bag of mortar per 40 – 50 ft2 (3.7 – 4.6 m 2 ).
Is thinset the preferred method of installation over Ditra?
At an NTCA / Schluter workshop the statement was made that the preferred method of installation over ditra is the use of an unmodified thinset. Mass confusion ensued.
What is the best product to set over Kerdi or Ditra?
Ditra-Set: This is the best product with which to set anything over kerdi or ditra – it was specifically manufactured for that purpose. The availability is extremely limited, however. Most professionals don’t have ready access to it, let alone regular homeowners. So just plan on not finding this.